最新人気 cisco-ASA5585-S60-2A-K9_medium ルーター

ciscoasa> en
Password:
ciscoasa# show version

Cisco Adaptive Security Appliance Software Version 9.8(4)22
Firepower Extensible Operating System Version 2.2(2.124)
Device Manager Version 7.12(2)

Compiled on Fri 29-May-20 00:44 PDT by builders
System image file is "disk0:/asa984-22-smp-k8.bin"
Config file at boot was "startup-config"

ciscoasa up 52 secs

Hardware: ASA5585-SSP-10, 5969 MB RAM, CPU Xeon 5500 series 2000 MHz, 1 CPU (4 cores)
Internal ATA Compact Flash, 2048MB
BIOS Flash M25P32 @ 0x0, 4096KB

Encryption hardware device : Cisco ASA-5585 on-board accelerator (revision 0x1)
Boot microcode : CNPx-MC-BOOT-2.00
SSL/IKE microcode : CNPx-MC-SSL-SB-PLUS-0005
IPSec microcode : CNPx-MC-IPSEC-MAIN-0026
Number of accelerators: 1

Programmable device : Cisco CPLD revision 0x8

0: Int: Internal-Data0/0 : address is 0000.0001.0001, irq 5
2: Int: Internal-Data0/1 : address is 0000.0001.0002, irq 10
3: Ext: Management0/0 : address is 6073.5c28.ecd0, irq 10
4: Ext: Management0/1 : address is 6073.5c28.ecd1, irq 5
16: Ext: GigabitEthernet0/0 : address is 6073.5c28.ecd2, irq 255
17: Ext: GigabitEthernet0/1 : address is 6073.5c28.ecd3, irq 255
18: Ext: GigabitEthernet0/2 : address is 6073.5c28.ecd4, irq 255
19: Ext: GigabitEthernet0/3 : address is 6073.5c28.ecd5, irq 255
20: Ext: GigabitEthernet0/4 : address is 6073.5c28.ecd6, irq 255
21: Ext: GigabitEthernet0/5 : address is 6073.5c28.ecd7, irq 255
22: Ext: GigabitEthernet0/6 : address is 6073.5c28.ecd8, irq 255
23: Ext: GigabitEthernet0/7 : address is 6073.5c28.ecd9, irq 255
24: Ext: TenGigabitEthernet0/8: address is 6073.5c28.ecda, irq 255
25: Ext: TenGigabitEthernet0/9: address is 6073.5c28.ecdb, irq 255
26: Int: Internal-Data0/2 : address is 0000.0100.001b, irq 255
27: Int: Internal-Data0/3 : address is 0000.0100.001c, irq 255
28: Int: Not used : irq 255
29: Int: Not used : irq 255
30: Int: Not used : irq 255
31: Int: Not used : irq 255
32: Int: Not used : irq 255
33: Int: Not used : irq 255

Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 1024 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
Encryption-DES : Enabled perpetual
Encryption-3DES-AES : Enabled perpetual
Security Contexts : 10 perpetual
Carrier : Disabled perpetual
AnyConnect Premium Peers : 5000 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 5000 perpetual
Total VPN Peers : 5000 perpetual
AnyConnect for Mobile : Enabled perpetual
AnyConnect for Cisco VPN Phone : Enabled perpetual
Advanced Endpoint Assessment : Enabled perpetual
Shared License : Disabled perpetual
Total TLS Proxy Sessions : 2 perpetual
Botnet Traffic Filter : Disabled perpetual
10GE I/O : Disabled perpetual
Cluster : Disabled perpetual

This platform has an ASA5585-SSP-10 VPN Premium license.

Serial Number: ***********
Running Permanent Activation Key: 0x1c01f172 0x6c975b0c 0xe88279b4 0xa3881ca8 0x413225ae
Configuration register is 0x1

Image type : Release
Key version : A

Configuration has not been modified since last system restart.
ciscoasa# show inventory
Name: "module 0", DESCR: "ASA 5585-X Security Services Processor-10 with 8GE"
PID: ASA5585-SSP-10 , VID: V04 , SN: ***********

Name: "Chassis", DESCR: "ASA 5585-X"
PID: ASA5585 , VID: V03 , SN: ***********

Name: "power supply 0", DESCR: "ASA 5585-X AC Power Supply"
PID: ASA5585-PWR-AC , VID: V04 , SN: ***********

Name: "power supply 1", DESCR: "ASA 5585-X AC Power Supply"
PID: ASA5585-PWR-AC , VID: V04 , SN: ***********

ciscoasa# show module

Mod Card Type Model Serial No.
---- -------------------------------------------- ------------------ -----------
0 ASA 5585-X Security Services Processor-10 wi ASA5585-SSP-10 ***********

Mod MAC Address Range Hw Version Fw Version Sw Version
---- --------------------------------- ------------ ------------ ---------------
0 6073.5c28.ecd0 to 6073.5c28.ecdb 2.0 2.0(13)0 9.8(4)22

Mod SSP Application Name Status SSP Application Version
---- ------------------------------ ---------------- --------------------------

Mod Status Data Plane Status Compatibility
---- ------------------ --------------------- -------------
0 Up Sys Not Applicable

ciscoasa# show environment

Cooling Fans:
-----------------------------------

Power Supplies:
--------------------------------
Left Slot (PS0): 5900 RPM - OK (Power Supply Fan)
Right Slot (PS1): 5900 RPM - OK (Power Supply Fan)

Power Supplies:
-----------------------------------
Power Supply Unit Redundancy: OK

Left Slot (PS0): Present
Right Slot (PS1): Present

Power Input:
--------------------------------
Left Slot (PS0): OK
Right Slot (PS1): OK

Temperature:
--------------------------------
Left Slot (PS0): 23 C - OK (Power Supply Temperature)
Right Slot (PS1): 23 C - OK (Power Supply Temperature)

Cooling Fans:
--------------------------------
Left Slot (PS0): 6000 RPM - OK (Power Supply Fan)
Right Slot (PS1): 6000 RPM - OK (Power Supply Fan)

Temperature:
-----------------------------------

Processors:
--------------------------------
Processor 1: 43.0 C - OK (CPU1 Core Temperature)

Chassis:
--------------------------------
Ambient 1: 26.5 C - OK (Chassis Front Temperature)
Ambient 2: 32.5 C - OK (Chassis Back Temperature)
Ambient 3: 24.25 C - OK (CPU1 Front Temperature)
Ambient 4: 27.75 C - OK (CPU1 Back Temperature)

IO Hub:
--------------------------------
Circuit Die: 43.0 C - OK (Circuit Die Temperature)

Power Supplies:
--------------------------------
Left Slot (PS0): 23 C - OK (Power Supply Temperature)
Right Slot (PS1): 23 C - OK (Power Supply Temperature)

Voltage:
-----------------------------------
Channel 1: 3.353 V - (3.3V (U142 VX1))
Channel 2: 1.496 V - (1.5V (U142 VX2))
Channel 3: 1.049 V - (1.05V (U142 VX3))
Channel 4: 3.337 V - (3.3V_STDBY (U142 VP1))
Channel 5: 11.697 V - (12V (U142 VP2))
Channel 6: 4.939 V - (5.0V (U142 VP3))
Channel 7: 6.935 V - (7.0V (U142 VP4))
Channel 8: 9.988 V - (IBV (U142 VH))
Channel 9: 1.047 V - (1.05VB (U209 VX2))
Channel 10: 1.214 V - (1.2V (U209 VX3))
Channel 11: 1.108 V - (1.1V (U209 VX4))
Channel 12: 1.007 V - (1.0V (U209 VX5))
Channel 13: 3.335 V - (3.3V STDBY (U209 VP1))
Channel 14: 2.501 V - (2.5V (U209 VP2))
Channel 15: 1.803 V - (1.8V (U209 VP3))
Channel 16: 1.901 V - (1.9V (U209 VP4))
Channel 17: 10.004 V - (IBV (U209 VH))
Channel 18: 2.048 V - (VTT CPU0 (U83 VX2))
Channel 19: 0.000 V - (VTT CPU1 (U83 VX3))
Channel 20: 2.048 V - (VCC CPU0 (U83 VX4))
Channel 21: 1.773 V - (VCC CPU1 (U83 VX5))
Channel 22: 1.519 V - (1.5VA (U83 VP1))
Channel 23: 0.001 V - (1.5VB (U83 VP2))
Channel 24: 8.937 V - (IBV (U83 VH))

ALARM CONTACT 1
Status: not asserted
Description: external alarm contact 1
Severity: minor
Trigger: closed

ALARM CONTACT 2
Status: not asserted
Description: external alarm contact 2
Severity: minor
Trigger: closed

Driver Information:
--------------------
Status : RUNNING

Driver Error Statistics:
-------------------------
I2C I/O Errors : 0
GPIO Errors : 0
Ioctl Null Ptr Errors : 0
Poll Errors : 0
Invalid Ioctl Errors : 0
PECI Errors : 2
Unknown Errors : 0


ciscoasa#